 | | Re: 6L technic sloped piece
|
|
(...) Hi If you can wait till monday, I can sent it to you. (up to 0.1 degree precision..:-) Selçuk (26 years ago, 7-Nov-98, to lugnet.cad)
|
| |
| | Re: 6L technic sloped piece
|
|
(...) That'll be great! :-) Fredrik (26 years ago, 8-Nov-98, to lugnet.cad)
|
| |
| | Re: 6L technic sloped piece
|
|
I believe I found the answer myself by looking at the LDraw parts file. If I'm not mistaken, the angle is arctan(32/78) = 22.3° Fredrik (26 years ago, 9-Nov-98, to lugnet.cad)
|
| |
| | Re: 6L technic sloped piece
|
|
Fredrik Glöckner wrote in message ... (...) Absolutely right. It is axactly 22 degrees and 29 minutes. (with 1 minute precision) regards Selçuk (26 years ago, 9-Nov-98, to lugnet.cad)
|
| |
| | Re: 6L technic sloped piece
|
|
Selçuk <teyyareci> <sgore@nospam.superonline.com> wrote (...) Um, 0.3 degrees is 18 minutes not 29. Unless Fredrik meant 30 minutes... Moz (26 years ago, 10-Nov-98, to lugnet.cad)
|
| |
| | Re: 6L technic sloped piece
|
|
Moz (Chris Moseley) wrote in message ... (...) Oh, sorry about that, I just figured out this after my posting, But this is what my quality control technician measured on a projection measurment device. Selçuk (26 years ago, 10-Nov-98, to lugnet.cad)
|
