 | | 6L technic sloped piece —Fredrik Glöckner
|
| | | Do anybody know the _exact_ angle of the sloped plane on the 6L technic beam with sloped end? Fredrik (26 years ago, 7-Nov-98, to lugnet.cad)
|
| | | |
| | | | | Re: 6L technic sloped piece —Selçuk Göre
|
| | | | (...) Hi If you can wait till monday, I can sent it to you. (up to 0.1 degree precision..:-) Selçuk (26 years ago, 7-Nov-98, to lugnet.cad)
|
| | | | |
| | | | | | Re: 6L technic sloped piece —Fredrik Glöckner
|
| | | | (...) That'll be great! :-) Fredrik (26 years ago, 8-Nov-98, to lugnet.cad)
|
| | | | |
| | | | | | Re: 6L technic sloped piece —Fredrik Glöckner
|
| | | | I believe I found the answer myself by looking at the LDraw parts file. If I'm not mistaken, the angle is arctan(32/78) = 22.3° Fredrik (26 years ago, 9-Nov-98, to lugnet.cad)
|
| | | | |
| | | | | | Re: 6L technic sloped piece —Selçuk Göre
|
| | | | Fredrik Glöckner wrote in message ... (...) Absolutely right. It is axactly 22 degrees and 29 minutes. (with 1 minute precision) regards Selçuk (26 years ago, 9-Nov-98, to lugnet.cad)
|
| | | | |
| | | | | | Re: 6L technic sloped piece —Chris Moseley
|
| | | | Selçuk <teyyareci> <sgore@nospam.superonline.com> wrote (...) Um, 0.3 degrees is 18 minutes not 29. Unless Fredrik meant 30 minutes... Moz (26 years ago, 10-Nov-98, to lugnet.cad)
|
| | | | |
| | | | | | Re: 6L technic sloped piece —Selçuk Göre
|
| | | | Moz (Chris Moseley) wrote in message ... (...) Oh, sorry about that, I just figured out this after my posting, But this is what my quality control technician measured on a projection measurment device. Selçuk (26 years ago, 10-Nov-98, to lugnet.cad)
|
| | | | |
