 | | Re: Getting a bad impression?
|
|
There is another possibility to consider. Maybe the currently active part authors (such as me) do not have a copy of this part to work from. Also, I seem to recall that someone had finished this part, but it had size problems. Does anyone remember (...) (25 years ago, 14-Jun-99, to lugnet.cad)
|
| |
| | Re: Getting a bad impression?
|
|
I can understand Doyle's impatience, but I also am aware that making good LDraw parts is difficult. The tools available are not like mainstream 3D design tools. That could also be a contributing factor. As far as the Castle doors go, if John is (...) (25 years ago, 15-Jun-99, to lugnet.cad)
|
| |
| | Re: Getting a bad impression?
|
|
(...) LDraw (...) I see you have a lot of patience in waiting for a part too. The thing is I am working on a project that is costing me about $4000.00 to $6000.00 and I can complete it without the door because the instructions for it are made layer (...) (25 years ago, 15-Jun-99, to lugnet.cad)
|
| |
| | Re: Getting a bad impression?
|
|
(...) ! I had no idea that such levels of cashflow could come from using LDraw. Cheers, - jsproat (25 years ago, 15-Jun-99, to lugnet.cad)
|
| |
| | Re: Getting a bad impression?
|
|
Doyle Nelson wrote in message ... (...) This may just be me, but I'd make a mock-up of it and use that as a place-holder until I got the real part. Even just whatever hinge bits it has plus a plate in the middle would do, and it's a lot better than (...) (25 years ago, 17-Jun-99, to lugnet.cad)
|
| |
| | Re: Getting a bad impression?
|
|
Moz (Chris Moseley) <moz1@ihug.com.au> wrote in message news:FDGwqs.L4H@lugnet.com... (...) am (...) can (...) by (...) place-holder (...) in (...) that (...) when (...) sample (...) Now _that's_ sure to clear up that bad impression :) -John Van (25 years ago, 17-Jun-99, to lugnet.cad)
|
