Subject:
|
Re: SR 3D Builder 0.4.5.7 RELEASED
|
Newsgroups:
|
lugnet.cad
|
Date:
|
Sun, 10 Jan 2010 09:25:35 GMT
|
Viewed:
|
19701 times
|
| |
|
|
In lugnet.cad, Andy Lynch wrote:
> In lugnet.cad, Andy Lynch wrote:
> > In lugnet.cad, Sergio Reano wrote:
> > > Hi,
> > > new SR 3D Builder 0.4.5.7 has been just release and is online as always on
> > > http://staff.polito.it/sergio.reano/
>
>
> Ok, a couple of hours later, and a few things to mention...
>
> Doesn't support MPD files yet, at least not ones that I have that work fine in
> MLCad.
>
> Can't seem to figure out how groups work, if at all.
>
> Files that are saved have three unusual characters at the very beginning that
> other programs have an issue with, including MLCad and LDView, which are the
> main tools that I use. If I use LDraw Design Pad to remove those characters,
> everything is fine. If I just load the file in the other tools, the those
> characters make the first piece invalid, so it doesn't show up.
If that three characters looks like  then it is the BOM for UTF-8.
For official DAT-Files it is recommended to use either ASCII or UTF-8 without
the BOM (as they are equal in the ASCII range of characters).
http://en.wikipedia.org/wiki/UTF-8
So this should be changed in SR 3D Builder to be interchangeable with the other
tools.
I came across this a while ago at developing DATHeader.
cu
mikeheide
|
|
Message is in Reply To:
 | | Re: SR 3D Builder 0.4.5.7 RELEASED
|
| (...) Ok, a couple of hours later, and a few things to mention... Doesn't support MPD files yet, at least not ones that I have that work fine in MLCad. Can't seem to figure out how groups work, if at all. Files that are saved have three unusual (...) (17 years ago, 10-Jan-10, to lugnet.cad)
|
12 Messages in This Thread:
 
  
- Entire Thread on One Page:
- Nested:
All | Brief | Compact | Dots
Linear:
All | Brief | Compact
|
|
|
|
