Subject:
|
Re: Slope Brick 1x1
|
Newsgroups:
|
lugnet.cad
|
Followup-To:
|
lugnet.robotics
|
Date:
|
Sat, 27 Sep 2008 16:54:00 GMT
|
Viewed:
|
8106 times
|
| |
|
|
In lugnet.cad, Kevin L. Clague wrote:
> the sin of the angle is height/hypotenuse
> from there you take the sin inverse to get the angle.
Hmm. Is there some reason you couldn't just jump right to using Tan?
Tan(theta) = opposite/adjacent
--
Brian Davis
|
|
Message has 2 Replies:
 | | Re: Slope Brick 1x1
|
| (...) Why does the follow-up go to the Robotics group? This is a CAD / LDraw issue, so it should be lugnet.cad.dat.parts. (My mistake in the first place to post it to lugnet.cad ;-) (16 years ago, 29-Sep-08, to lugnet.cad)
|
Message is in Reply To:
| | Re: Slope Brick 1x1
|
| (...) The part file has the dimensions needed to answer this question. The triangles on the sides tell you the width and height of the end. From there you can calculate the length of the hypotenuse. h = sqrt(w*w+h*h) the sin of the angle is (...) (16 years ago, 27-Sep-08, to lugnet.cad)
|
13 Messages in This Thread:
  
 
- Entire Thread on One Page:
- Nested:
All | Brief | Compact | Dots
Linear:
All | Brief | Compact
This Message and its Replies on One Page:
- Nested:
All | Brief | Compact | Dots
Linear:
All | Brief | Compact
|
|
|
|
