 | | Re: LPub4 Alpha3 available —Jaco van der Molen
|
| | | (...) OK. I tested the results using 11.0 by 8.5 which results in a landscape page fitting the page area. Unfortunately my design does not fit anymore, but I guess I have to edit it to get a landscape result. Back to the drawing board for me, I say! (...) (16 years ago, 25-Jun-08, to lugnet.cad, FTX)
|
| | | |
| | | | | Re: LPub4 Alpha3 available —Kevin L. Clague
|
| | | | (...) I'd start with Assem Setup and Parts List Setup and reduce the scale. Kevin (16 years ago, 25-Jun-08, to lugnet.cad, FTX)
|
| | | | |
| | | | | | Re: LPub4 Alpha3 available —Jaco van der Molen
|
| | | | (...) Too late :-( I have redesigned the complete layout and am however more satified with it then with the previous version. So I guess I was lucky with this bug ;-) (16 years ago, 26-Jun-08, to lugnet.cad, FTX)
|
| | | | |
| | | | | | Re: LPub4 Alpha3 available —Kevin L. Clague
|
| | | | (...) Hi Jaco, Just curious.... How many total steps in the model (i.e. how many pages before you did any step groups or callouts)? How many pages after laying out the BIs with LPub 4? How long did it take to layout the BIs? Kevin (16 years ago, 26-Jun-08, to lugnet.cad, FTX)
|
| | | | |
| | | | | | Re: LPub4 Alpha3 available —Jaco van der Molen
|
| | | | (...) It had 111 steps (thus pages). Now it has 44! It took about 2 to 3 hours to layout the basics and another hour or so to fine tune. All in all about 3 to 4 hours, I guess. Modelling it (creating the MPD) took many more hours though. If you take (...) (16 years ago, 27-Jun-08, to lugnet.cad, FTX)
|
| | | | |
