Subject:
|
"Studless" 4592 (was: "Studless" hinges?)
|
Newsgroups:
|
lugnet.cad, lugnet.cad.dat.parts
|
Date:
|
Tue, 22 Jan 2008 13:19:46 GMT
|
Viewed:
|
4869 times
|
| |
![Post a public reply to this message](/news/icon-reply.gif) | |
In lugnet.cad, Daniel Collis wrote:
> I'm referring to part 4592.dat (Hinge Control Stick Base). When I render
> (POV-Ray 3.6) images with this part with the studs setting set to 0, only the
> top portion of the part is showing. When I looked at the part in MLCad I can see
> that it uses a stud as it's base. Is there a version of it that isn't built this
> way? It's something I need in a "crap load" of models to render.
I'll post a version in just a minute.
Steve
|
|
Message is in Reply To:
![](/news/x.gif) | | "Studless" hinges?
|
| I'm referring to part 4592.dat (Hinge Control Stick Base). When I render (POV-Ray 3.6) images with this part with the studs setting set to 0, only the top portion of the part is showing. When I looked at the part in MLCad I can see that it uses a (...) (16 years ago, 22-Jan-08, to lugnet.cad)
|
5 Messages in This Thread: !["Studless" hinges? -Daniel Collis (22-Jan-08 to lugnet.cad)](/news/x.gif) ![](/news/246.gif) ![You are here](/news/here.gif)
![](/news/x.gif) ![](/news/68.gif) ![Re: "Studless" hinges? -Daniel Collis (25-Jan-08 to lugnet.cad)](/news/x.gif) ![](/news/46.gif) ![Re: "Studless" hinges? -Philippe Hurbain (25-Jan-08 to lugnet.cad)](/news/x.gif) ![](/news/46.gif) ![Re: "Studless" hinges? -Daniel Collis (26-Jan-08 to lugnet.cad)](/news/x.gif)
- Entire Thread on One Page:
- Nested:
All | Brief | Compact | Dots
Linear:
All | Brief | Compact
|
|
|
|