Subject:
|
Re: Animation problem
|
Newsgroups:
|
lugnet.cad
|
Date:
|
Wed, 23 Aug 2006 16:11:46 GMT
|
Viewed:
|
1487 times
|
| |
|
|
Hello,
when I assembled my small animations/motion blur pictures, I sometimes forgotten
to clean the “trash” of previous povray runs. For example if you run 8 pictures
with some lightning setup, frames file01... to file08... will be created.
After adjusting the lights and processing 121 frames you get
file001...,...,file008...file121.... The 01...08 were not overwritten and are
sorted alphabetically inside the range of the 121 frames. That could cause such
jumps in the pictures.
But this is only a possible reason...
Inside the pov code of your message I do not see any reason for your problem.
Andreas
|
|
Message is in Reply To:
 | | Re: Animation problem
|
| (...) Hi Jindrich, Did I briefly speak to you at 1000steine land about this? Try turning off radiosity and see if the problem goes away. The way that povray approximates radiosity could easily be to blame. Tim (18 years ago, 23-Aug-06, to lugnet.cad)
|
4 Messages in This Thread:
  
- Entire Thread on One Page:
- Nested:
All | Brief | Compact | Dots
Linear:
All | Brief | Compact
|
|
|
|
