Subject:
|
Re: Scale issues
|
Newsgroups:
|
lugnet.cad
|
Date:
|
Fri, 14 Oct 2005 13:51:34 GMT
|
Viewed:
|
1377 times
|
| |
|
|
Sorry 'bout that.
I'm modeling a tacho wheel, and I used the core off of one of the double bevel
gears that I brought into Blender, which means that I should've started at the
right scale to begin with. After I was done, I also brought in an axle into
Blender to double check, and it all fits perfectly. The Blender import brings
the .dat files in at the right size. However, when I try to export it back out,
to use in MLCad, the tacho wheel always come out too small. The edges of the
tacho wheel are the same diameter as a 1x1 round, always, no matter if I scale
it up or down in Blender. The tacho wheels core that fits around the axle ought
to be that diameter, but not the whole piece.
I 'preciate the help!
-Stefan-
|
|
Message is in Reply To:
 | | Re: Scale issues
|
| (...) Dear Stefan, I'm not really sure what you mean here. If you give a little more detail of what you did it might be easier to help. Tim (19 years ago, 14-Oct-05, to lugnet.cad)
|
3 Messages in This Thread:
 
- Entire Thread on One Page:
- Nested:
All | Brief | Compact | Dots
Linear:
All | Brief | Compact
|
|
|
|
