Subject:
|
Re: Scale issues
|
Newsgroups:
|
lugnet.cad
|
Date:
|
Fri, 14 Oct 2005 09:46:08 GMT
|
Viewed:
|
1043 times
|
| |
|
|
In lugnet.cad, Stefan Garcia wrote:
> Hi all,
>
> I made a quick model of the Tacho Wheel for a friend, and exported it out of
> Blender. It shows up in MLCAD, but it's never the right size. I've tried
> scaling it up and down, and it makes no difference to the end file
> apparently. Is there a way to force this in the .dat file, or is there
> something else I need to do?
>
> Any help'd be much appreciated, and apologies if I put this in the wrong
> group.
>
> -Stefan-
Dear Stefan,
I'm not really sure what you mean here. If you give a little more detail of what
you did it might be easier to help.
Tim
|
|
Message has 1 Reply:
 | | Re: Scale issues
|
| Sorry 'bout that. I'm modeling a tacho wheel, and I used the core off of one of the double bevel gears that I brought into Blender, which means that I should've started at the right scale to begin with. After I was done, I also brought in an axle (...) (19 years ago, 14-Oct-05, to lugnet.cad)
|
Message is in Reply To:
| | Scale issues
|
| Hi all, I made a quick model of the Tacho Wheel for a friend, and exported it out of Blender. It shows up in MLCAD, but it's never the right size. I've tried scaling it up and down, and it makes no difference to the end file apparently. Is there a (...) (19 years ago, 14-Oct-05, to lugnet.cad, FTX)
|
3 Messages in This Thread:
 
- Entire Thread on One Page:
- Nested:
All | Brief | Compact | Dots
Linear:
All | Brief | Compact
This Message and its Replies on One Page:
- Nested:
All | Brief | Compact | Dots
Linear:
All | Brief | Compact
|
|
|
|
