Subject:
|
Re: No PLI in Layout
|
Newsgroups:
|
lugnet.cad
|
Date:
|
Thu, 9 Jun 2005 12:31:32 GMT
|
Viewed:
|
982 times
|
| |
|
|
In lugnet.cad, Jaco van der Molen wrote:
> In lugnet.cad, Kevin L. Clague wrote:
> > In lugnet.cad, Jaco van der Molen wrote:
> Hmm. This does not seem to work either. Here is what I did:
> 1. Open the LDR file in LPub
> 2. Uncheck PLIs at the Global tab in the Generate section
> 3. Generate CSI,PLI and BOM = this does the job: create step images, no PLI
> 4. Generate Layout = this makes Layout with step images + PLI
> 5. Delete the PLI files (_x_xx_parts.PNG) in the directory Layout
> 6. Generate Layout again = still PLI's present
Delete PLI files in images directory too.
Kevin
|
|
Message has 1 Reply:
 | | Re: No PLI in Layout
|
| "Kevin L. Clague" <kevin_clague@yahoo.com> schreef in bericht news:IHtHGK.1qr0@lugnet.com... (...) Following the steps I describe there are no PLI files in the images directory (due to step 2 I guess?) Any thoughts? Jaco (19 years ago, 9-Jun-05, to lugnet.cad)
|
Message is in Reply To:
| | Re: No PLI in Layout
|
| (...) Hmm. This does not seem to work either. Here is what I did: 1. Open the LDR file in LPub 2. Uncheck PLIs at the Global tab in the Generate section 3. Generate CSI,PLI and BOM = this does the job: create step images, no PLI 4. Generate Layout = (...) (19 years ago, 9-Jun-05, to lugnet.cad)
|
8 Messages in This Thread:
  
- Entire Thread on One Page:
- Nested:
All | Brief | Compact | Dots
Linear:
All | Brief | Compact
This Message and its Replies on One Page:
- Nested:
All | Brief | Compact | Dots
Linear:
All | Brief | Compact
|
|
|
|
