To LUGNET HomepageTo LUGNET News HomepageTo LUGNET Guide Homepage
 Help on Searching
 
Post new message to lugnet.cadOpen lugnet.cad in your NNTP NewsreaderTo LUGNET News Traffic PageSign In (Members)
 CAD / 12063
    Re: 3 x 2 Wedge Plates —David Laswell
   (...) They're way at the very end of the Wedge grouping, just before the Wheel grouping starts. They're listed as Wedge Plate 2 x 3 Left/Right. The 2x4 versions are listed as Wings, and the double-wide versions of the same are listed as Wedge 3x4 (...) (20 years ago, 31-Oct-04, to lugnet.cad)
   
        Re: 3 x 2 Wedge Plates —Chris Dee
   (...) We are aware that this is unsatisfactory, and there is an ongoing effort by the LDraw parts librarians to standardise thse names. Wedge plates will probably all become Wings. Chris (20 years ago, 31-Oct-04, to lugnet.cad)
   
        Re: 3 x 2 Wedge Plates —Allan Bedford
     (...) That would seem to make sense. They share the characteristics with wing plates of being more-or-less a scalene triangle(1) and coming in both a left and right configuration. Regards, Allan B. (1) Depending on how you classify/measure notched (...) (20 years ago, 31-Oct-04, to lugnet.cad)
   
        Re: 3 x 2 Wedge Plates —David Laswell
   (...) Please understand that I wasn't harping on it to you guys. I had my bit of that, then Steve explained the situation to me (that it's a known problem, that it's being discussed, and that all Wedge Plates will probably end up as Wings), and now (...) (20 years ago, 31-Oct-04, to lugnet.cad)
 

©2005 LUGNET. All rights reserved. - hosted by steinbruch.info GbR