To LUGNET HomepageTo LUGNET News HomepageTo LUGNET Guide Homepage
 Help on Searching
 
Post new message to lugnet.cadOpen lugnet.cad in your NNTP NewsreaderTo LUGNET News Traffic PageSign In (Members)
 CAD / 10419
    Re: Overlapping polygons etc —Ross Crawford
   (...) OK, using your example as a guide, I finished off the part. First cut is at (URL) did notice, though, that using LDview, there is a definite line where the studs join the cylinders. I tried rotating the studs by 22.5 degrees to match, but the (...) (21 years ago, 6-Aug-03, to lugnet.cad)
   
        Re: Overlapping polygons etc —Steve Bliss
   (...) Leave the studs at 0 rotation. I didn't see the lines you mention. Steve (21 years ago, 12-Aug-03, to lugnet.cad)
 

©2005 LUGNET. All rights reserved. - hosted by steinbruch.info GbR