To LUGNET HomepageTo LUGNET News HomepageTo LUGNET Guide Homepage
 Help on Searching
 
Post new message to lugnet.cadOpen lugnet.cad in your NNTP NewsreaderTo LUGNET News Traffic PageSign In (Members)
 CAD / 10195
    Keyboard input problems in LeoCAD —Allan Bedford
   Help! O.K. as far as I can remember, from the work I did in LeoCAD last weekend, the arrow keys move the selected part by 1/2 stud increments, unless the CRTL key is held down. However, as I'm working today, I'm noticing that the arrow keys are (...) (21 years ago, 7-Jun-03, to lugnet.cad, lugnet.cad.leocad)
   
        Problem solved (WAS: Keyboard input problems in LeoCAD) —Allan Bedford
   (...) After more trial and error, I found the answer to this problem. From what I can tell, the movement increments are not set on the Preferences panel. There is a display in the status bar called 'Move' which is a clickable menu. This isn't (...) (21 years ago, 8-Jun-03, to lugnet.cad.leocad)
   
        Re: Problem solved (WAS: Keyboard input problems in LeoCAD) —Leonardo Zide
   (...) You probably pressed the '1' key. Leonardo (21 years ago, 9-Jun-03, to lugnet.cad.leocad)
   
        Re: Problem solved (WAS: Keyboard input problems in LeoCAD) —Kyle Henneberque
   (...) Pressing '1' or '2' etc. changes the movement to that many studs. To get it back to half a stud press the '0'. Kyle (21 years ago, 10-Jun-03, to lugnet.cad.leocad)
   
        Re: Problem solved (WAS: Keyboard input problems in LeoCAD) —Allan Bedford
   (...) I only wish that information was in the help file (1)... my bald spot grew just a little bit larger during the frustrating time I couldn't move a brick 1/2 stud increments. :) I actually ended up changing it by clicking on the status bar (...) (21 years ago, 10-Jun-03, to lugnet.cad.leocad)
 

©2005 LUGNET. All rights reserved. - hosted by steinbruch.info GbR