To LUGNET HomepageTo LUGNET News HomepageTo LUGNET Guide Homepage
 Help on Searching
 
Post new message to lugnet.cadOpen lugnet.cad in your NNTP NewsreaderTo LUGNET News Traffic PageSign In (Members)
 CAD / *44096 (-5)
  Re: Conditional Ring primitive?
 
(...) That's a primitive I have been longing for... but I realized it is impossible to build: where would you put the control lines? The top control points would need to be scaled differently from bottom ones to match various cylinders/cones (...) (16 years ago, 12-Dec-08, to lugnet.cad)
 
  Conditional Ring primitive?
 
(...) I just noticed something else while investigating a fix for the above problem. The above model could really use a circular conditional edge primitive. I would vote for x-ycedge.dat as the filename (ie 1-4cedge.dat, 4-4cedge.dat, (...) (16 years ago, 12-Dec-08, to lugnet.cad)
 
  Re: Colinear Vertices
 
(...) I played with the settings, and I had to set the precision all the way down to 0.133 in order to get it to fully smooth. (0.125 failed to smooth properly.) (...) .005. I think I'll set the precision to .01, to hopefully give it some leeway. I (...) (16 years ago, 12-Dec-08, to lugnet.cad)
 
  Re: LETGUI new version 0.1.0.18
 
(...) Thanks! For the record: - Ytruder 1.2 is no longer limited to Y direction and can extrude along x, y or z directions - Intersector 1.3 has a new scaling option that improves result for small parts. Philo (16 years ago, 12-Dec-08, to lugnet.cad.dev)
 
  Re: Colinear Vertices
 
(...) It makes sense! (...) An example, this button: (URL) I rounded condlines to 2 decimal places since I couldn't get smoothing anyway. I did more experiments, with full precision in condline it works: (URL) but after rounding to 3 dp there is no (...) (16 years ago, 12-Dec-08, to lugnet.cad)


Next Page:  5 more | 10 more | 20 more

Redisplay Messages:  All | Compact

©2005 LUGNET. All rights reserved. - hosted by steinbruch.info GbR