 | | Re: Colinear Vertices
|
|
(...) It makes sense! (...) An example, this button: (URL) I rounded condlines to 2 decimal places since I couldn't get smoothing anyway. I did more experiments, with full precision in condline it works: (URL) but after rounding to 3 dp there is no (...) (18 years ago, 12-Dec-08, to lugnet.cad)
|
| |
| | LETGUI new version 0.1.0.18
|
|
A new version of LETGUI ((URL) is now available. Support for new commandline options for Ytruder1.2 and Intersector1.3 are added. Have fun! cu mikeheide (18 years ago, 12-Dec-08, to lugnet.cad.dev)
|
| |
| | Re: x210c01 ChromeSilver Drill 4 x 4 x 7
|
|
(...) Welcome back! (...) I agree with Mikeheide, since the total curvature is low I think 6 cones would be more than enough! (...) Seems a good approach. As for the edge line between screw and cones, Isecalc will provide it instantly! (It would be (...) (18 years ago, 12-Dec-08, to lugnet.cad.dat.parts)
|
| |
| | Re: x210c01 ChromeSilver Drill 4 x 4 x 7
|
|
(...) I do not understand correctly what you are saying. If you use a cone primitive you can stretch it in all direction. There is no need to use "about 40 cones". A maximum of 10 should do the same! You should use for this the program "cones and (...) (18 years ago, 12-Dec-08, to lugnet.cad.dat.parts)
|
| |
| | Re: x210c01 ChromeSilver Drill 4 x 4 x 7
|
|
(...) Just to refresh my memory ( I haven't done any parts since 2951) The 48 primitives divide a circle in 48 straight lines, right? That would for a 60 LDU diameter mean that each straight line is approx 4 LDU's long, so using coneshapes each 4 (...) (18 years ago, 11-Dec-08, to lugnet.cad.dat.parts)
|
