 | | Re: Copy of MacMegaPov 0.7
|
|
I realized that in my previous message, I never actually mentioned that I built the executable that I link to. I built it from the MegaPOV 0.7 source using (mostly) the Unix settings from the regular POV source. I set it to output PNG files by (...) (17 years ago, 21-Jul-07, to lugnet.cad.dev.mac, FTX)
|
| |
| | Re: Copy of MacMegaPov 0.7
|
|
(...) You can find a command-line Intel Mac compile of MegaPOV 0.7 here: (URL) I tested it with the following command line: megapov +IBRICKS.pov I used BRICKS.pov from the above zip, and it generated the following two PNG files in under 2 seconds: (...) (17 years ago, 21-Jul-07, to lugnet.cad.dev.mac, FTX)
|
| |
| | Re: Copy of MacMegaPov 0.7
|
|
(...) Establishing a consistent way to create quality instructions from LDraw models on the Mac is of great interest to me, personally and on behalf of the general Mac LDraw community. If a detailed tutorial is not practical, I would still be (...) (17 years ago, 20-Jul-07, to lugnet.cad.dev.mac, FTX)
|
| |
| | Re: Copy of MacMegaPov 0.7
|
|
(...) I have a copy sitting here: (URL) I got it by e-mailing the maintainers of MacMegaPOV several years ago. In later correspondence, they also told me the edge-tracer in the newer version of MacMegaPOV had not been optimized by its author. The (...) (17 years ago, 20-Jul-07, to lugnet.cad.dev.mac, FTX)
|
| |
| | Re: Brickshelf Backup Crawler for Mac
|
|
(...) Of course, I just tried bsbackup.sh again - the current version that gets all files - and it took 32:05. There's a little quicktime movie in there that probably accounts for most of the difference as the MPD files are quite small. So the (...) (17 years ago, 18-Jul-07, to lugnet.general, lugnet.cad.dev.mac, FTX)
|
