| | Re: Isecalc, a LDraw intersection line calculator
|
|
(...) hi philo, cute! would it be possible to pack the prog along with the samples and a .pdf of the howto in one file? w. (17 years ago, 27-May-07, to lugnet.cad.dev)
|
|
| | Re: tool for patterned parts
|
|
Anders Isaksson schrieb: (...) Hi Anders, I have found many curved parts with pattern on the curved surface. Also I think of stickers that can be done with such a program. I think it could work as follow: 1) Do a scan of the curved part (You need to (...) (17 years ago, 27-May-07, to lugnet.cad)
|
|
| | Re: Isecalc, a LDraw intersection line calculator
|
|
(...) Hi Philo, Very cool software tool. I'm sure I'll be using this at some point. Tim (17 years ago, 26-May-07, to lugnet.cad.dev, FTX)
|
|
| | Isecalc, a LDraw intersection line calculator
|
|
(2 URLs) Isecalc> utility, intended for LDraw parts authors, computes the intersection line of two sets of triangles or quads. Each set is provided to the utility as separate LDraw files. A third file containing the intersection lines is created. (...) (17 years ago, 26-May-07, to lugnet.announce, lugnet.cad.dev, FTX)
|
|
| | New FastRad Radiosity Settings
|
|
Greetings everyone! You may or may not have seen some of the renders I've made on my (URL) Brickshelf Folder>. A while ago, I posted my 'FastRad' settings there, but I think that they were a bit too messy and complicated. I have since cleaned them (...) (17 years ago, 25-May-07, to lugnet.cad.ray, lugnet.cad, FTX)
|
|
| | Re: LDraw Wiki - Beta release
|
|
(...) Please note that you will need to set up a new account for the wiki. Unfortunately it is difficult to share accounts from the main site. Sorry about this. Tim (17 years ago, 25-May-07, to lugnet.cad.dev.org.ldraw)
|
|
| | LDraw Wiki - Beta release
|
|
Hi all, Following recent discussions, Dan Boger has very kindly set us up a wiki for LDraw. This is intended to be a way for anyone to add 'content' of relavence to LDraw easily and without relying on the time of the webmasters to integrate it into (...) (17 years ago, 25-May-07, to lugnet.cad.dev.org.ldraw)
|
|
| | Re: Tread part and use in MLCAD
|
|
(...) Have you tried LSynth? If I recall, it supports this part. Maybe kevin can chime in help you out. -Orion (17 years ago, 23-May-07, to lugnet.cad)
|
|
| | Tread part and use in MLCAD
|
|
Hello, I have visited this topic a few times without much progress, but perhaps I am simply missing some key information. I have the need to use this tread part: (URL) to be x203) I recall it took a while to find it (I think because there was only a (...) (17 years ago, 23-May-07, to lugnet.cad)
|
|
| | Re: Custom Logo on Minifig
|
|
(...) If you want it right on an actual physical minifig, Tommy Armstrong can take care of that for you: (URL) sure how you'd go about doing it digitally, though. (17 years ago, 23-May-07, to lugnet.cad)
|