 | | Re: LDD questions
|
|
(...) I remember searching for that in 1.6... how frustrating! Try to hit the arrow on your keyboard when placing the brick (it should not just be selected, but be ready to place (moving with your pointer thus) Hope it helps, Jean-Marc (18 years ago, 25-Mar-07, to lugnet.cad.ldd)
|
| |
| | LDD questions
|
|
1. How do you rotate a brick in LDD? - it does't mention it in the help - I must be stupid! 2. When I export to Ldraw I just get the 1st 2 lines, the other export formats look OK? Thanks, David (18 years ago, 25-Mar-07, to lugnet.cad.ldd)
|
| |
| | Re: instructions needed
|
|
(...) (URL) (18 years ago, 25-Mar-07, to lugnet.cad.dat.parts, lugnet.znap, lugnet.technic.roboriders, lugnet.technic, lugnet.technic.bionicle)
|
| |
| | Re: Light is too bright!
|
|
(...) They should probably be less bright, you can multiply the whole RGB triple by a constant less than 1: ... 0.4 * <r, g, b> It would also help changing the 'fade_distance' and 'fade_power' to make them not shine so far. Or you could change them (...) (18 years ago, 25-Mar-07, to lugnet.cad.ray)
|
| |
| | instructions needed
|
|
Does anybody has instructions for these models of the roborider series? (URL) help is welcome. mikeheide (18 years ago, 25-Mar-07, to lugnet.cad.dat.parts, lugnet.znap, lugnet.technic.roboriders, lugnet.technic, lugnet.technic.bionicle)
|
| |
| | Re: Underside stud groups
|
|
Mark Kennedy schrieb: (...) I think this is not necessary. The other stud groups are created mainly for the baseplates and there are no underside studs. mikeheide (18 years ago, 25-Mar-07, to lugnet.cad.dat.parts)
|
| |
| | Re: Problems with Online Hobby Train Instructions
|
|
(...) Thanks, I never would've gotten there without a nudge. Mike (18 years ago, 25-Mar-07, to lugnet.trains, lugnet.cad.ldd)
|
| |
| | Re: Light is too bright!
|
|
(...) Maybe it shows better how dominating the red light is in this frame: (URL) (18 years ago, 25-Mar-07, to lugnet.cad.ray)
|
| |
| | Light is too bright! [DAT]
|
|
Hi all! Is there a way to make the red tail-lights shine a little less brightly? I use the following code, 1 36 -50 -55 108 -1 0 0 0 0 -1 0 -1 0 4073.DAT 1 36 50 -55 108 -1 0 0 0 0 -1 0 -1 0 4073.DAT 1 15 -50 -53 108 1 0 0 0 1 0 0 0 1 light.dat 1 15 (...) (18 years ago, 25-Mar-07, to lugnet.cad.ray)
|
| |
| | Underside stud groups
|
|
Does anybody think that there should be stud groups for the undersides of plates made up of STUD4 type studs? Was wondering how much support there is for such primitives before submitting any to the tracker. (18 years ago, 24-Mar-07, to lugnet.cad.dat.parts)
|
