 | | New parts: yellow drive rod and red holder [DAT]
|
|
Last weekend I finished the red holder part for the old yellow steam train drive rod. In this first version I ommited the small gap near the centre stud hole. For the real part this gap is used to make the hole stretch a bit to fit the stud of a (...) (20 years ago, 27-Sep-04, to lugnet.cad.dat.parts)
|
| |
| | Re: Adjustable paths for parts
|
|
(...) Thanx for the update on this! I just have to be patient. (In the meanwhile I use a copy of the parts library, mixed with all the unofficial parts I need, at a different location on my harddisk, which I use for rendering now with the old L3P) (...) (20 years ago, 27-Sep-04, to lugnet.cad)
|
| |
| | Re: Problem with 41760 (mirrored 41770)
|
|
First of all, the mirroring trick is the standard way to make pairs of parts like that. It uses the least number of bytes in the parts library, and properly behaved software shouldn't care. (Since I wrote LDView, I'm allowed to say that without (...) (20 years ago, 27-Sep-04, to lugnet.cad, FTX)
|
| |
| | Problem with 41760 (mirrored 41770)
|
|
I've noticed something odd when using the two 2x4 wedge plates 41769 and 41770. 41769 appears to have been built using what I consider a rather bad method of mirroring 41770 by applying a scaling/rotation matrix "trick". The problem this appears to (...) (20 years ago, 27-Sep-04, to lugnet.cad, FTX)
|
| |
| | Re: Adjustable paths for parts
|
|
(...) It's coming! We agreed how it should work and I promised to make the software, which will be open source available to all CAD programmers. The software is done, I have integrated it in L3P and tested it and it works fine. I have also been (...) (20 years ago, 26-Sep-04, to lugnet.cad)
|
