 | | Re: ldraw based import parts
|
|
Hi Thomas, are you still around?? I think I'm finally going to be able to prototype some of these parts for you, and I had a few questions: Re: 42440 Is this a lowered chassis? Or is it the same as combining four 2x3 plates and two 2x2s with axles? (...) (20 years ago, 16-Jul-04, to lugnet.cad)
|
| |
| | Re: Blender LDraw support
|
|
(...) Part detection is problematic due to changes over time in the library. For reference, LDView uses the following to identify parts: File is in the Parts directory, and isn't a descendent of any other parts at the time the file is loaded (sub (...) (20 years ago, 15-Jul-04, to lugnet.cad.dev)
|
| |
| | Re: LDRAWPREDIRS LDRAWPOSTDIRS - additional search paths
|
|
(...) Directory separators were added in DOS 2, which accepted both / and \ for that purpose. The feature was imitated from Unix. At the time, there also appeared a config.sys setting for *switch* character, which would default to / but could be set (...) (20 years ago, 15-Jul-04, to lugnet.cad.dev)
|
| |
| | Re: Variants of 4.5v / 12v train motors
|
|
(...) Would you be able to take a critical look at the sizes of the connector studs and the holes in them. There is a suggestion that these differ between the versions designed to work with the old Blue 2-pin connectors ((URL) those which fit the (...) (20 years ago, 15-Jul-04, to lugnet.cad.dev, lugnet.trains)
|
| |
| | Re: Contributer Agreement v2
|
|
(...) Thanks! Maybe even crosslink, with the first post in the continued tree pointing (with an explicit label) back to the root of the previous tree too. (...) Yes! (20 years ago, 15-Jul-04, to lugnet.cad.dev.org.ldraw, lugnet.admin.general)
|
