 | | part(s) posted... (set #4817)
|
|
I went with pattern number "4f", since "4b" has been taken by some other torso. Minifig Hips & Legs with Leather Armor Pattern (Complete) (URL) Hips with Leather Belt (Red Studs) Pattern (URL) Leg Right with Leather Straps (Red Studs) Pattern (URL) (...) (23 years ago, 10-Apr-02, to lugnet.cad.dev)
|
| |
| | Re: Beta testers needed
|
|
I've created a temporary webpage for LD4DModeler, in time you can download the beta there. The url is: (URL) (23 years ago, 10-Apr-02, to lugnet.cad)
|
| |
| | Re: Parts as volumes (instead of surfaces)
|
|
(...) That was only bounding boxes (minus the studs). The piece in question was matched against all other pieces, any pieces in a line above or below were put into a list. In case one of them intersected the piece in question, a new place would be (...) (23 years ago, 10-Apr-02, to lugnet.cad.dev.org.ldraw)
|
| |
| | Enhancement request - File dialogs
|
|
I think the File dialogs could benefit from some improvement in how path is determined. This applies to at least export model and export submodels (in Multipart mode) Both default to the root of the C drive and don't remember last filepath selected. (...) (23 years ago, 10-Apr-02, to lugnet.cad.mlcad)
|
| |
| | Re: Parts as volumes (instead of surfaces)
|
|
(...) So stud4 would be decomposed into 16 trapezoidal prisms? That sounds like a fair amount of mark up. (...) Nod, true. But I'd rather decompose a 1x1 brick into 6 volumes (4 walls, 1 top and the stud) than 46 (one volume for each surface (...) (23 years ago, 10-Apr-02, to lugnet.cad.dev.org.ldraw)
|
| |
| | Re: panel with round windows (for 10020) updated
|
|
(...) I stand corrected- I didn't realize that L3P did that. I just checked through the text file and found the reference to it. So yes, using primitives is a better way to go. Ugh, and now I have to rethink how I lay out some parts, as the (...) (23 years ago, 10-Apr-02, to lugnet.cad.dat.parts)
|
| |
| | Re: GPF on manual zoom in MLCad 2.11
|
|
(...) Hey, neat tip! Thanks. (23 years ago, 10-Apr-02, to lugnet.cad.mlcad)
|
| |
| | Re: matching pattern numbers???
|
|
(...) When reasonable, yes, we should. If I make the Johnny Thunder face today, but don't make his torso for a couple of years, I wouldn't expect that the same pattern number will necessarily be available later. There are too many patterns for that. (...) (23 years ago, 10-Apr-02, to lugnet.cad.dev)
|
| |
| | "tangenting"
|
|
Is there an easy way to rotate by dragging in MLCAD? I have a situation where I want something to be tangent to two things and it's a complex 3 dimensional angle to calculate. I know the endpoints, more or less. What I would like to be able to do is (...) (23 years ago, 10-Apr-02, to lugnet.cad.mlcad)
|
| |
| | Re: In progress.
|
|
She is good model you guys should Look at it. could be in your town too. (23 years ago, 10-Apr-02, to lugnet.cad)
|
