 | | Re: LDraw syntax check in Perl
|
|
(...) The return values from the check routines indicate what kind of syntax was detected. Even values - bad syntax was found Odd values - no bad syntax More specifically, the following values are added together to get the complete return value: 1 - (...) (23 years ago, 11-Jul-01, to lugnet.cad.dev)
|
| |
| | New Part: 70961 - Bumper 2 x 4 Rubber [DAT]
|
|
Here is the 2x4 rubber bumper from set 8824. I guess I oughta try and take a look at the 1x4 holder brick and the corner versions too. Chris 0 Bumper 2 x 4 Rubber 0 Name: 70961.DAT 0 Author: Chris Dee (chris_w_dee@hotmail.com) 0 Unofficial Part 0 (...) (23 years ago, 11-Jul-01, to lugnet.cad.dat.parts)
|
| |
| | New Part: 3297p90 - Slope Brick 33 3 x 4 with Classic Space Pattern [DAT]
|
|
Thanks to advice from Willy Tschager here is one more (maybe the last) Classic Space decorated part - the 3x4 slope from set 6970. Chris 0 Slope Brick 33 3 x 4 with Classic Space Pattern 0 Name: 3297p90.DAT 0 Author: Chris Dee (...) (23 years ago, 11-Jul-01, to lugnet.cad.dat.parts)
|
| |
| | Re: Naming of pieces
|
|
[ Note: I'm crossposting this to lugnet.cad, but with a FUT to lugnet.db.inv so that it doesn't fill up both groups if the thread grows. CAD folks who have an interest in this thread, please come over to db.inv and give your two cents. ] (...) (...) (23 years ago, 11-Jul-01, to lugnet.db.inv, lugnet.cad)
|
| |
| | Re: Naming of pieces
|
|
(...) Roger that. I've copied lugnet.cad because peeron uses the LDraw nomenclature and that is where you would need to campaign for name changes. I agree, in general that small and large (1) are not good names, I would prefer dimensions given in (...) (23 years ago, 11-Jul-01, to lugnet.db.inv, lugnet.cad)
|
