| | Re: MLCAD introductory info
|
|
"Bram Lambrecht" <bram@cwru.edu> wrote in message news:004301c0f280$9a...erv.net... (...) I new there was something that already did this, but I couldn't remember what it was. Guess I'll have to look at using LDAO again to make this easier. One (...) (23 years ago, 11-Jun-01, to lugnet.cad.mlcad)
|
|
| | Re: MLCAD introductory info
|
|
(...) program (...) The Inline function in LDAO (by Steve Bliss) takes all the referenced subfiles in a DAT file and merges them into one file by transforming the parts. However, with the popularity of MPD, fewer people are inlining than they used (...) (23 years ago, 11-Jun-01, to lugnet.cad.mlcad)
|
|
| | Re: MLCAD introductory info
|
|
(...) You are right. That is absolutely what it did. I went through my sub models one by one to: - Create a comment line telling me where each submodel started - Opened both the master file and the submodel file in Notepad - Copied the submodel (...) (23 years ago, 11-Jun-01, to lugnet.cad.mlcad)
|
|
| | Re: Has anyone made or has made plans to make this part?
|
|
I asked for the same part as well in (URL) have given it a try myself, but it is too difficult for me to make. Greetingz... Sjaacko Anthony Sava <savatheaggie@yahoo.com> schreef in berichtnieuws GEoCvw.11t@lugnet.com... (...) sets (...) brick (...) (...) (23 years ago, 11-Jun-01, to lugnet.cad.dat.parts)
|
|
| | Re: MLCAD introductory info
|
|
"Ryan Farrington" <ryanjf@ifriendly.com> wrote in message news:000b01c0f0e1$03...dly.com... (...) with (...) If you do this then you end up with referenced parts in the dat that don't exist as they were part of the mpd format, and you get all the (...) (23 years ago, 11-Jun-01, to lugnet.cad.mlcad)
|