 | | Re: Newbie question about MLCad
|
|
(...) You are rotating it around a centre point which is represented by a cross that you will find somewhere on the model, you can grab this and drag it to the point around which you would like to rotate. Once you have performed the rotation right (...) (23 years ago, 6-Jun-01, to lugnet.cad.mlcad)
|
| |
| | LDAO DOS Boxes
|
|
Hi all, OK, now that I have installed LDAO again, I get two DOS boxes that don't close when I start it. 1. vecprof 2. partprof Did I miss something here? I guess it has to do with some ini file? Greetingz... Sjaacko (23 years ago, 6-Jun-01, to lugnet.cad)
|
| |
| | Re: Problem finding standard parts in MLCAD
|
|
OK, thanks all! Jaco (...) (23 years ago, 6-Jun-01, to lugnet.cad.mlcad)
|
| |
| | Newbie question about MLCad
|
|
Everytime I need to rotate a piece, it moves off the model. Then when I try to place it back where it belongs, it's off center (it's not completely on both of the studs). It seems hard to explain without a picture so let me know if you need one. -- (...) (23 years ago, 6-Jun-01, to lugnet.cad.mlcad)
|
| |
| | Re: Problem finding standard parts in MLCAD
|
|
(...) I know the version you mean. One important note about that: It was <NOT> LDAO that was the problem! Steve Bliss would never have let something like that through! The problem was the self-extracting installation program he packaged it in. He (...) (23 years ago, 6-Jun-01, to lugnet.cad.mlcad)
|
| |
| | Re: Problem finding standard parts in MLCAD
|
|
(...) Yes, there is that. I am using an older version. I thought Steve had put back a stable (older) version on the download site but I may be wrong. I do have the install image for that older version around somewhere if folks needed it. It hasn't (...) (23 years ago, 6-Jun-01, to lugnet.cad.mlcad)
|
| |
| | Re: Problem finding standard parts in MLCAD
|
|
Is LDAO stable? The last time I installed it, I had to reinstall my machine... :-( (...) (23 years ago, 6-Jun-01, to lugnet.cad.mlcad)
|
| |
| | Re: Problem finding standard parts in MLCAD
|
|
(...) If regenerating doesn't do it for you, because you just can't remember that, for example, garage door slats are filed under Roller and not garage and not door and not panel and not slat.... (yes, I was trying to find these today, no comment on (...) (23 years ago, 6-Jun-01, to lugnet.cad.mlcad)
|
| |
| | Re: Problem finding standard parts in MLCAD
|
|
(...) That seems to have done it! Thanks! Jake --- Jake McKee AFOL LUGNET Member #211 (23 years ago, 6-Jun-01, to lugnet.cad.mlcad)
|
| |
| | Re: Problem finding standard parts in MLCAD
|
|
did you hit regenerate list? mine was same way heh -- And they said 'Computers will never be in general use' "Jake McKee" <sink@countersinkdg.com> wrote in message news:GEHnoC.Ftz@lugnet.com... (...) brick, (...) I (...) (23 years ago, 6-Jun-01, to lugnet.cad.mlcad)
|
