 | | Re: On the difficulty of making building instructions
|
|
(...) Your Phd thesis is not about 3D CAD interfaces then I take it? (Which incidentally is an area of Computing Research if you know WHERE to look and ask..) (...) This sounds like a good technique... Audible feedback.. However my qyery is how easy (...) (24 years ago, 7-Feb-01, to lugnet.cad)
|
| |
| | Re: LCAD/LDraw.org Formal Organization
|
|
(...) OK but you would need at least a chairman or tresuarer... Also .. "Politics is often about the 'details' " ;-) Quote from a UK MP but cant remember which one.. (...) OK Point taken- Looking at your list it seems you have more of a software (...) (24 years ago, 7-Feb-01, to lugnet.cad.dev.org.ldraw)
|
| |
| | Re: On the difficulty of making building instructions
|
|
(...) BlockCad (and perhaps other programs) does some collision detection when moving the bricks to assist in the placement. You could enhance this by inventing a mouse that provides some tactile feedback (ala playstation controllers) when the (...) (24 years ago, 7-Feb-01, to lugnet.cad)
|
| |
| | Re: Question on transparent printed parts
|
|
(...) Yes, you canread about it here: (URL) (24 years ago, 7-Feb-01, to lugnet.cad.dev)
|
| |
| | Re: L3PAO small update available
|
|
(...) Another easier solution to the international settings problem is to change the way L3PAO saves it's comma delimited settings from: 1,1,2,0,5,1, ..... to "1","1","2","0,5",1", ..... so you will have no more problems with international settings! (...) (24 years ago, 7-Feb-01, to lugnet.cad)
|
| |
| | Re: L3PAO small update available
|
|
(...) Hmm.. that's odd, because L3PAO should check for POV and still continue even if it isn't found. But then again, I've never tested it on a system that *didn't* have POV installed. Tonight I'll try uninstalling my POV and see if I get the same (...) (24 years ago, 7-Feb-01, to lugnet.cad)
|
| |
| | On the difficulty of making building instructions
|
|
On the difficulty of making building instructions: Last sunday I spent most of the day (except for a few hours out in the snow) showing my cousins how to make - or should I say _draw_ - building instructions on a computer. Personally I use (...) (24 years ago, 7-Feb-01, to lugnet.cad)
|
| |
| | Re: New Part - 3900 Minifig Signal Holder
|
|
(...) The edge lines from the handle extend into the circular panel. This won't look too good if the part is transparent. Plus the angle of entry for the edge lines is narrow so it throws off the edge line offset in ldglite at certain viewing (...) (24 years ago, 7-Feb-01, to lugnet.cad.dat.parts)
|
| |
| | Re: L3PAO small update available
|
|
(...) (24 years ago, 7-Feb-01, to lugnet.cad)
|
| |
| | Re: L3PAO small update available
|
|
Hi Jeff (and others) I have installed all that I (should) need, but L3PAO won't run for me. I have Windows NT 4.0 workstation. I have installed the VB 6.0 files, I have the latest COMDLG32.OCX in my winnt\system32 directory, but when I click (...) (24 years ago, 7-Feb-01, to lugnet.cad)
|
