Subject:
|
Re: L3PAO small update available
|
Newsgroups:
|
lugnet.cad
|
Date:
|
Wed, 7 Feb 2001 17:59:37 GMT
|
Viewed:
|
692 times
|
| |
|
|
> There's still an outstanding problem of international settings causing issues.
> In locations where people use a comma to denote decimal places (i.e. 1.5 is
> written 1,5). This wreaks havoc when scene files are saved because the scene
> files are comma-delimited. Lars suggested a replace routine to scan for commas
> in values that need to have periods, I just haven't gotten around to trying
> it out.
Another easier solution to the international settings problem is to change
the way L3PAO saves it's comma delimited settings from:
1,1,2,0,5,1, .....
to
"1","1","2","0,5",1", .....
so you will have no more problems with international settings!
George
|
|
Message is in Reply To:
 | | Re: L3PAO small update available
|
| (...) Hmm.. that's odd, because L3PAO should check for POV and still continue even if it isn't found. But then again, I've never tested it on a system that *didn't* have POV installed. Tonight I'll try uninstalling my POV and see if I get the same (...) (24 years ago, 7-Feb-01, to lugnet.cad)
|
6 Messages in This Thread:
  
- Entire Thread on One Page:
- Nested:
All | Brief | Compact | Dots
Linear:
All | Brief | Compact
|
|
|
|
