Subject:
|
Re: tightening up mecha joints
|
Newsgroups:
|
lugnet.build.mecha
|
Date:
|
Thu, 17 Aug 2000 14:41:16 GMT
|
Viewed:
|
669 times
|
| |
|
|
In lugnet.build.mecha, Mark Sandlin writes:
> I use Saran Wrap, personally, but I suppose any thin material will do.
Silicon tape should work well. You can findn it in the plumbing section of a
hardware store. It is a white tape (no sticky) about 3/8" wide. It is very
stretchy and will conform very tightly to any shape. It's used on the threads
of pipe for gas lines. It provides a more perfect seal.
Good Luck,
Gino A...
|
|
Message has 1 Reply:
 | | Re: tightening up mecha joints
|
| (...) a (...) Teflon Pipe Tape! Yes!! I've got tons of that stuff! I'll give that a try, or the Saran Wrap (thanks Mike). I tried scotch tape, but it wouldn't conform to the holes well enough. I love Lugnet. You guys rock :) Adrian -- (URL) (25 years ago, 17-Aug-00, to lugnet.build.mecha)
|
Message is in Reply To:
9 Messages in This Thread:
 
 
- Entire Thread on One Page:
- Nested:
All | Brief | Compact | Dots
Linear:
All | Brief | Compact
This Message and its Replies on One Page:
- Nested:
All | Brief | Compact | Dots
Linear:
All | Brief | Compact
|
|
|
|
