Subject:
|
tightening up mecha joints
|
Newsgroups:
|
lugnet.build.mecha
|
Date:
|
Thu, 17 Aug 2000 12:15:53 GMT
|
Viewed:
|
534 times
|
| |
|
|
What's the best way to tighten up technic friction pin joints used for mecha?
I have an old-style technic pin (a little tighter than the newer ones with the
rectangular cutouts) holding the shoulders and hips of my new mech together.
The shoulders hold poses quite adequately with nothing in the mech's hands.
However, when i give him a big gun to hold, his shoulder slowly drops. Is
there any easy way to tighten this joint up, or am I going to have to resort
to something bizarre with rubber bands or something?
Adrian
--
http://junior.apk.net/~tremor/lego.html
|
|
Message has 1 Reply:
 | | Re: tightening up mecha joints
|
| (...) Well, it's kinda annoying to do, but something I did for my mech (the legs would just bow right out when I tried to pose him) was a method using paper slips. I cut some very narrow slips of paper, and for each technic pin joint, I would stick (...) (24 years ago, 17-Aug-00, to lugnet.build.mecha)
|
9 Messages in This Thread:
  
- Entire Thread on One Page:
- Nested:
All | Brief | Compact | Dots
Linear:
All | Brief | Compact
|
|
|
|
