Subject:
|
Re: Ball Joint Frame ZRX1 version
|
Newsgroups:
|
lugnet.build.mecha
|
Date:
|
Sun, 13 Mar 2005 21:43:10 GMT
|
Viewed:
|
958 times
|
| |
|
|
In lugnet.build.mecha, Eric Sophie wrote:
| |
MC7 Ball Joint Frame ZRX1 version.
|
Click “Next” to see the show,
the ZRX1 Classified Development File:
http://www.brickshelf.com/cgi-bin/gallery.cgi?i=1144262
I felt inspired to experiment with this new technology.
I made a new hand hybrid with reverse minifig legs and lever fingers
and changed the forearm a bit to accomodate it by using a new friction axle pin
for the forearm twist.
I discovered the shoulder joint’s tendancy to separate, without an axle glued or
otherwise permanently attached to the ball, and made a little drama about the
circumstances of this discovery.
The skinnable ball joint frame is really great technology. I just barely have
enough ball joints to make one, though plenty of parts for a skin. The kit is
definitely a good idea.
K
|
|
Message has 1 Reply:
Message is in Reply To:
11 Messages in This Thread:
  
 
- Entire Thread on One Page:
- Nested:
All | Brief | Compact | Dots
Linear:
All | Brief | Compact
This Message and its Replies on One Page:
- Nested:
All | Brief | Compact | Dots
Linear:
All | Brief | Compact
|
|
|
|
