 | | 1x1x1 studless corner slope?! —Shiri Dori
|
| | | I was just helping my baby-sittees organize their lego when I ran into a 1x1x1 convex corner slope piece. The only way to decribe it otherwise is: this piece is what you'd get if you would cut the 1x2x1 slope peak into two right down the middle. I (...) (25 years ago, 2-Apr-00, to lugnet.build, lugnet.general)
|
| | | |
| | | | | Re: 1x1x1 studless corner slope?! —Richard W. Schamus
|
| | | | (...) is more than on plate high,(you sure to find it to be a plate and one half or half a full brick high before it slopes; 2)there are lines of plastic inside the bottom on all 4 sides to help grip it to the/a stud; 3) there is a small diameter (...) (25 years ago, 2-Apr-00, to lugnet.build, lugnet.general)
|
| | | | |
| | | | | | Re: 1x1x1 studless corner slope?! —Shiri Dori
|
| | | | (...) Thanks. I figured... especially after I got home and tried it out with my lego and found that it didn't match the red lego color, and it didn't have lego printed on it. Also the texture of the slope was different. I didn't realize these before (...) (25 years ago, 2-Apr-00, to lugnet.build, lugnet.general)
|
| | | | |
| | | | | | Re: 1x1x1 studless corner slope?! —Gary R. Istok
|
| | | | (...) I'm no expert on Tyco, but I do have a few pieces (from a red Castle set). And the only slopes that were in the set were 1x4x3 low slope roof bricks in gray. They appear identical to the Lego low slopes in gray, with nearly an identical shade (...) (25 years ago, 3-Apr-00, to lugnet.build, lugnet.general)
|
| | | | |
