To LUGNET HomepageTo LUGNET News HomepageTo LUGNET Guide Homepage
 Help on Searching
 
Post new message to lugnet.buildOpen lugnet.build in your NNTP NewsreaderTo LUGNET News Traffic PageSign In (Members)
 Building / 1898
    Re: My new Engine: SD70M —Bram Lambrecht
   (...) a (...) have (...) ribs. I'm not sure I understand how you did it. Could you explain a little more? (A dat post in lugnet.cad.dat.ideas would be even better) --Bram Bram Lambrecht / o o \ BramL@juno.com ---...---oooo-----(_...o---...--- WWW: (...) (25 years ago, 23-Jul-99, to lugnet.build, lugnet.trains)
   
        Re: My new Engine: SD70M —Bryce McGlone
      (...) Okay here's where I get to admit how computer illiterate I am. I don't even know how to do a dat post. I'll go try to figure that out after this. I was writing about "turning" Lego plates 90 degrees to achieve a finer way of lettering. (...) (25 years ago, 23-Jul-99, to lugnet.build, lugnet.trains)
   
        Re: My new Engine: SD70M —Bryce McGlone
   (...) Okay now I just loaded Cad draw. I wish I'd known about this sooner. Give me a day or so and I'll make a quick mock up of a few ideas. (25 years ago, 23-Jul-99, to lugnet.build, lugnet.trains)
   
        Re: My new Engine: SD70M —Bram Lambrecht
   On Fri, 23 Jul 1999 07:06:40 GMT (...) I think I understand now (I understood how you made the signs, but I didn't understand how that could be applied to a circular rose window). Please don't stop using LDraw though! If you need any help, please (...) (25 years ago, 23-Jul-99, to lugnet.build, lugnet.trains)
 

©2005 LUGNET. All rights reserved. - hosted by steinbruch.info GbR