 | | Re: Railing prototype for heavy cruiser —Lindsay Frederick Braun
|
| | | (...) The obvious solution for me is a frame-by-frame construction, with each stud being rendered into a "frame." So I'll be building the flare out SNOTwise below deck level. I have frame-by-frame diagrams of _Takao_ which shall be adequate. It's (...) (23 years ago, 17-May-02, to lugnet.build, lugnet.build.military)
|
| | | |
| | | | | Re: Railing prototype for heavy cruiser —Kenneth Tam
|
| | | | (...) Interesting. I've been trying to figure out a stable solution for strange curves like that for my next wet-navy project... this might be what I'm looking for. Hmm... (...) Small favors, eh? : ) Kenneth Tam (23 years ago, 17-May-02, to lugnet.build, lugnet.build.military)
|
| | | | |
| | | | | | Re: Railing prototype for heavy cruiser —Lindsay Frederick Braun
|
| | | | (...) What I do is build the general curve around the blocky basis of the hull--you know, a vertically straight horizontal curve. Then I build the curve outward on that. It does mean that my internal order is square; but it also means that I can use (...) (23 years ago, 17-May-02, to lugnet.build, lugnet.build.military)
|
| | | | |
