 | | Half-Stud Offset Building —Erik Olson
|
| | | This feels like a kind of dark side (painting or cutting bricks) but I've just crossed over to using half-stud offset techniques. Are there other ways to do this without 1x2 center-stud tiles? Some have used them to create half-stud setbacks or (...) (23 years ago, 7-Oct-01, to lugnet.build)
|
| | | |
| | | | | Re: Half-Stud Offset Building —William R. Ward
|
| | | | | (...) Yes - the other way that I know of requires a piece with a hollow stud, and a 1x tile or brick. Tiles and bricks have "posts" which go between the studs normally. However they are the same diameter as the holes in hollow stud pieces (the 1x2 (...) (23 years ago, 7-Oct-01, to lugnet.build)
|
| | | | | |
| | | | | | | Re: Half-Stud Offset Building —Thomas Garrison
|
| | | | | | | (...) (URL) Garrison (23 years ago, 7-Oct-01, to lugnet.build)
|
| | | | | | | |
| | | | | | | Re: Half-Stud Offset Building —Erik Olson
|
| | | | | | Thanks, Bill, David, I'm trying some of these other pieces. hollow stud tops: In general there is the problem that the piece on top must be longer. I guess I could insert flat-topped support where the top pieces must meet. extreme slopes: These (...) (23 years ago, 7-Oct-01, to lugnet.build)
|
| | | | | | |
| | | | | Re: Half-Stud Offset Building —David Eaton
|
| | | | | (...) I can think of a few things-- 1. Various pieces have hollow studs on top. The obvious example being technic beams, but other things too. You can place these 1/2 stud off when placed underneath 1x bricks-- although note that the 1x brick must (...) (23 years ago, 7-Oct-01, to lugnet.build)
|
| | | | | |
| | | | | Re: Half-Stud Offset Building —Eric DeGiuli
|
| | | | | For a building I made, I had to make offsets like you are describing, and I used 1x1 round plates on top of plates. The result is shown in this picture: (URL) you look on top of the little frilly thing, ie the balcony, you can see a small gap (...) (23 years ago, 7-Oct-01, to lugnet.build)
|
| | | | | |
| | | | | (canceled) —Amy Hughes
|
| | | | | |
| | | | | | | Re: Half-Stud Offset Building —Chris Leach
|
| | | | | | (...) Wow looks good Amy! (23 years ago, 8-Oct-01, to lugnet.build)
|
| | | | | | |
| | | | | Re: Half-Stud Offset Building —Ray Sanders
|
| | | | (...) Plate 1 x 4 with Offset <part:4590> can be used also. When building my ferris- wheel, I needed to center a 6 x 6 plate in the middle of a 7-wide space. These did the job just fine. They may not disapear as seamlessly as the 1x2 plates with 1 (...) (23 years ago, 8-Oct-01, to lugnet.build)
|
| | | | |
