 | | Re: print removal
|
|
(...) I used an eraser to get the logo off of my one M-Tron trans-yellow-green 2x1x6H panel. It took a long time because there were two layers of paint for the two different colors. I didn't buff it at all, but the place where I erased became rather (...) (26 years ago, 5-Mar-99, to lugnet.build)
|
| |
| | Re: New creations on my website
|
|
(...) This is beautiful, in a nightmarish sort of way. Great architecture. Cheers, - jsproat (26 years ago, 5-Mar-99, to lugnet.build)
|
| |
| | Re: print removal
|
|
(...) I didn't try it on clear pieces, so your guess is as good as mine. I would suggest that you test it out first on a clear piece that you don't mind ruining. Even if your disposable piece has no printing, try erasing it for a miute or two, then (...) (26 years ago, 5-Mar-99, to lugnet.build)
|
| |
| | Re: print removal
|
|
(...) Did you use it on transparent pieces? I have some that I got from an Auczilla auction that I haven't found a use for yet because of the printing. The eraser technique sounds a lot friendlier than the sandpaper one I referred to earlier. I (...) (26 years ago, 5-Mar-99, to lugnet.build)
|
| |
| | Re: print removal
|
|
(...) Thanks for all the suggestions! There seemed to be a lot of support for the eraser technique, so I gave that a try. I used a Staedtler Mars Plastic eraser (commonly available at art supply stores). It took a lot of erasing, but caused very (...) (26 years ago, 5-Mar-99, to lugnet.build)
|
| |
| | Re: 1x1 and 2x2 chess sets
|
|
(...) In the left picture enlargement, look at the right white rook (right in the front bottom of the picture) and compare to the other rooks/ knights. Rob +---...---+ | Rob Farver - rfarver@rcn.com | | (URL) | | (URL) | +---...---+ (26 years ago, 5-Mar-99, to lugnet.cad, lugnet.build)
|
| |
| | Re: 1x1 and 2x2 chess sets
|
|
(...) Alright, I'm blind -- I still don't see it. What's the problem? Steve (26 years ago, 5-Mar-99, to lugnet.cad, lugnet.build)
|
| |
| | Re: 1x1 and 2x2 chess sets
|
|
(...) I don't know if the other cones will be as easy to fix as the 1x1x1. But I think they will (the main complication would be if the conic surface was interrupted by some feature). (...) Too bad; that one was aimed at you. ;) Steve (26 years ago, 5-Mar-99, to lugnet.cad, lugnet.build)
|
| |
| | Re: 1x1 and 2x2 chess sets
|
|
could i have the .dat files? (26 years ago, 5-Mar-99, to lugnet.cad, lugnet.build)
|
| |
| | Re: New creations on my website
|
|
Rob Farver wrote in message <36e0702b.23990668@l...et.com>... (...) Rob, where is the brown baseplate from? Eric (26 years ago, 5-Mar-99, to lugnet.build)
|
