Subject:
|
Re: print removal
|
Newsgroups:
|
lugnet.build
|
Date:
|
Fri, 5 Mar 1999 21:51:24 GMT
|
Viewed:
|
992 times
|
| |
|
|
Josh wrote:
> I didn't try it on clear pieces, so your guess is as good as mine.
I used an eraser to get the logo off of my one M-Tron trans-yellow-green
2x1x6H panel. It took a long time because there were two layers of
paint for the two different colors. I didn't buff it at all, but the
place where I erased became rather foggy, but still usable.
--Bram
Bram Lambrecht / o o \ BramL@juno.com
-------------------oooo-----(_)-----oooo-------------------
WWW: http://www.chuh.org/Students/Bram-Lambrecht/
-----------------------------------------------------------
|
|
Message is in Reply To:
 | | Re: print removal
|
| (...) I didn't try it on clear pieces, so your guess is as good as mine. I would suggest that you test it out first on a clear piece that you don't mind ruining. Even if your disposable piece has no printing, try erasing it for a miute or two, then (...) (26 years ago, 5-Mar-99, to lugnet.build)
|
7 Messages in This Thread:
  
- Entire Thread on One Page:
- Nested:
All | Brief | Compact | Dots
Linear:
All | Brief | Compact
|
|
|
|
