 | | Re: new program to aid part making: ldraw circle creator
|
|
(...) Could you set your line length to less than 80? The whole sentence above that starts with "I have to" is one huge long line. (26 years ago, 8-Apr-99, to lugnet.admin.general, lugnet.cad.dev)
|
| |
| | Re: new program to aid part making: ldraw circle creator
|
|
I'm sorry but it did not show up like that in email for me. I checked the message on the web and it was in your post that showed up with the line being long, not mine. Ryan ***...*** REPLY SEPARATOR ***...*** (...) (26 years ago, 9-Apr-99, to lugnet.admin.general, lugnet.cad.dev)
|
| |
| | Re: new program to aid part making: ldraw circle creator
|
|
Came out long to me as well. .02, John (...) (26 years ago, 9-Apr-99, to lugnet.admin.general)
|
| |
| | Re: new program to aid part making: ldraw circle creator
|
|
(...) That's probably because your newsreader isn't set to wrap out-going messages or it's line-wrapping is non-standard. The web interface may be able to understand the protocol, but not all other newsreaders do. When the message is replied to, it (...) (26 years ago, 9-Apr-99, to lugnet.admin.general, lugnet.cad.dev)
|
| |
| | Re: new program to aid part making: ldraw circle creator
|
|
I'll see if I can find a way to change it. I don't read all the groups so I don't see all the things like that that could be helpful. Ryan ***...*** REPLY SEPARATOR ***...*** (...) (26 years ago, 9-Apr-99, to lugnet.admin.general, lugnet.cad.dev)
|
| |
| | Re: new program to aid part making: ldraw circle creator
|
|
Ryan, Did you set your margins wide to post to cad.dat and then forget to set them back to 78 characters or so? I noticed you made a bunch of cad.dat posts lately, and I know I've forgotten in the past. -John Van SCOTT R DENNETT wrote in message (...) (26 years ago, 9-Apr-99, to lugnet.admin.general, lugnet.cad.dev)
|
| |
| | Re: new program to aid part making: ldraw circle creator
|
|
Um, I don't think that's possible because I haven't figured out how to change line length yet :) I will look into it though. Ryan ***...*** REPLY SEPARATOR ***...*** (...) (26 years ago, 10-Apr-99, to lugnet.admin.general, lugnet.cad.dev)
|
