| |
Um, I don't think that's possible because I haven't figured out how to change
line length yet :) I will look into it though.
Ryan
*********** REPLY SEPARATOR ***********
On 4/9/99, at 5:25 PM, John VanZwieten wrote:
> Ryan,
>
> Did you set your margins wide to post to cad.dat and then forget to set them
> back to 78 characters or so? I noticed you made a bunch of cad.dat posts
> lately, and I know I've forgotten in the past.
>
> -John Van
>
> SCOTT R DENNETT wrote in message <199904091649310170.01A13BDC@agate.net>...
> I'll see if I can find a way to change it. I don't read all the groups so I
> don't see all the things like that that could be helpful.
> Ryan
>
> *********** REPLY SEPARATOR ***********
>
> On 4/9/99, at 4:10 PM, Jeff Stembel wrote:
>
> > In lugnet.admin.general, Ryan Dennett writes:
> > > I'm sorry but it did not show up like that in email for me. I checked the
> > > message on the web and it was in your post that showed up with the line
> > > being long, not mine.
> >
> >
> > That's probably because your newsreader isn't set to wrap out-going messages • or
> > it's line-wrapping is non-standard. The web interface may be able to
> > understand the protocol, but not all other newsreaders do. When the message • is
> > replied to, it drops the protocol, resulting in everyone seeing it as a • single
> > line.
> >
> > Jeff
> >
> > P.S. Take this with a grain of salt, because most of my understanding of • line
> > wrapping stems from the discussion that went on here a couple months ago.
|
|
Message is in Reply To:
8 Messages in This Thread:
  
 
- Entire Thread on One Page:
- Nested:
All | Brief | Compact | Dots
Linear:
All | Brief | Compact
|
|
|
|
