|
|
 | | Re: general rambling (was: New angled beam)
|
| (...) I haven't seen the suspension setup of the 8448, but can it be that the shock absorber is closer to that chassis up front than rear? When using the 8880 setup, I've found this to be a problem. If you put the shock absorbers too close to the (...) (25 years ago, 7-Oct-99, to lugnet.technic)
| | | | | More IR proximity detectors
|
| We're trying to use the little radio shack IR transmitter and reciever units to build our own. We're not sure exactly how this will work, but before we get too far, is this a reasonable thing to do? Will these be strong enough to use as proximity (...) (25 years ago, 7-Oct-99, to lugnet.robotics.handyboard)
| | | | | Re: female figures
|
| (...) That's a little trickier, sad to say. Female figs in the castle line are few and far between - and most of the sets they come in are highly sought after. King's Mountain Fortress, Maiden's Cart, and Guarded Inn spring to mind, among others) (...) (25 years ago, 7-Oct-99, to lugnet.castle)
| | | | | Re: female figures
|
| (...) For less flowing skirts, you can also use a 1x2 brick stacked on two 1x2 plates. Steve (25 years ago, 7-Oct-99, to lugnet.castle)
| | | | | Re: Clipping / CCW / CW / INVERT
|
| Lots of good stuff in your post, Rui! (...) (Side note: there are not actually any solids in LDraw. Only lines and polygons). (...) Actually, since LDraw doesn't do shading, transparent surfaces *can* be clipped. Only edges, the top-most solid (...) (25 years ago, 7-Oct-99, to lugnet.cad.dev)
|
Skipped 1 message in
group
lugnet.off-topic.geek (Skip-filter settings)
|
