 | | Re: LPub questions
|
|
(...) I haven't found this command. You can set the default units to cm in Configuration > Preferences but I've found that doesn't work properly everywhere. I'm afraid we're stuck with inches for now. (...) I had the same problem: (URL) solution (...) (15 years ago, 16-Oct-09, to lugnet.cad)
|
| |
| | Re: L(EGO)Draw parts - 3rd batch
|
|
(...) You won't believe! Seriously, all the cheers go to the LEGO Universe Team!!! w. (15 years ago, 16-Oct-09, to lugnet.cad.dev.org.ldraw)
|
| |
| | Re: L(EGO)Draw parts - 3rd batch
|
|
(...) .dats are on my hard disk. I upload them once the list is clean. (...) A wiki page has been created at: (URL) sure you understand how wiki tables work. w. (15 years ago, 16-Oct-09, to lugnet.cad.dev.org.ldraw)
|
| |
| | Re: LPub questions
|
|
(...) Parts/models look fine in LDView. Changes I make in the PrefSet are reflected by LPub but cond lines are always drawn as edges. w. (15 years ago, 16-Oct-09, to lugnet.cad)
|
| |
| | Re: Say Hello to LEGO® Design byME LDD 3.0
|
|
(...) That is a good way of looking at it... Russell (15 years ago, 16-Oct-09, to lugnet.general, lugnet.mediawatch, FTX)
|
