 | | Toronto Tic Tac Toe - Game Board
|
|
A huge thank you to Iain who created a VERY nice Tic Tac Toe (TTT) game board. From here on out, THIS is the paper game board. (URL) Iain says: ----snip------- It should print out fine at 1:1 in this .PDF. You just have to make sure you un-check (...) (16 years ago, 10-Mar-09, to lugnet.org.ca.rtltoronto)
|
| |
| | Re: THE TORONTO TOY, TRAIN & DOLL COLLECTORS' SHOW APRIL 19, 2009
|
|
(...) Alright, I'll try and get as much done as I can! Cheers :) -Iain (16 years ago, 9-Mar-09, to lugnet.org.ca.obb)
|
| |
| | Re: A couple of gear questions
|
|
(...) No, it is not really a gear. You might be able to get two of them to mesh, but I wouldn't recommend it. It is used on the Code Pilot (and elsewhere) to measure rotation speed along with a light. (...) The 24 tooth clutch is a torque limiter. (...) (16 years ago, 9-Mar-09, to lugnet.technic, FTX)
|
| |
| | Re: A couple of gear questions
|
|
(...) Ah, right, so it is for that... I really have to find out how to measure torque. I, though, can't see the "2.5-5.0 Ncm" print on the part but I'll take your word for it. In lugnet.technic, Timothy P. Smith wrote: (...) I see... well I don't (...) (16 years ago, 9-Mar-09, to lugnet.technic)
|
| |
| | Re: Un-yellow old plastic - will it work on LEGO?
|
|
(...) ... Yes. I tried this last week and the results were very good. Take a look at this (URL) post>. The picture shows the results before and after a exposure of only 2 hours in the sun. We are having a heat wave here in Brazil and I was afraid of (...) (16 years ago, 9-Mar-09, to lugnet.general, lugnet.mediawatch, FTX)
|
