 | | Re: An aside on the "Plagiarism" thread...
|
|
Actually, it does make sense to "copyright" your designs. Let me explain: By placing a copyright notice on your webpage, you indicate that the original content (i.e. your creative ideas) is your intellectual property. Anyone who does not ask (...) (25 years ago, 26-Aug-99, to lugnet.general)
|
| |
| | Re: New web page (Was Re: Paul's claim to fame!)
|
|
Bram Lambrecht wrote in message ... (...) a (...) that (...) it: (...) Someone pointed this out on .build the other day - very cool, especially the use of the 1x2 rounded-top pieces to give more aesthetically pleasing contours[1], and retracting (...) (25 years ago, 26-Aug-99, to lugnet.general)
|
| |
| | new release???
|
|
Hi, I've been wondering why there hasn't been put out a newer release than 990330, especially since the rotation sensors doesn't work in it. But the error was identified way back in April by Mario Ferrari ((URL) STATE_0_VALUE (ds_unscale(1023U)) ... (...) (25 years ago, 26-Aug-99, to lugnet.robotics.rcx.legos)
|
| |
| | Re: Use a RCX as a Sensor port AND a Motor Output!
|
|
Ooops, subject should have been: Use RCX Sensor Port as a Sensor Port AND a Motor Output! Dave (25 years ago, 26-Aug-99, to lugnet.robotics)
|
| |
| | Use a RCX as a Sensor port AND a Motor Output!
|
|
So, I was messing around w/ the RCX and hooked up a Micromotor to one of my output ports and lo and behold....I could control the motor by toggling the Sensor Type for that port between a Passive (None, Switch, Temp) mode = OFF and an Active Mode (...) (25 years ago, 26-Aug-99, to lugnet.robotics)
|
