|
|
 | | RE: M68HC711E9
|
| O.K, , I still have a question. I'm working with a handy board and it use a special mode to talk to a LCD. If i understand , the handy board need to put the reset vector in the range BFC0 - BFFF. If get the aplication note for the 711E9 and ,as it (...) (27 years ago, 17-Jan-98, to lugnet.robotics.handyboard)
| | | | | Still problems to boot handyboard.
|
| I still have problems with two handyboards. I can download the code but never boot my code (that code run in other handy, however) Other variant is if i put a 69hc11a1fn the handy download the initiatl bootstrap code , and when try to syncronize (...) (27 years ago, 17-Jan-98, to lugnet.robotics.handyboard)
| | | | | Re: Shaft Encoders
|
| (...) Hi there, Would these chips be suitable for interfacing a mouse to the Handyboard? My robot incorporates a mouse as a castor wheel and I want to use its shaft encoders as position/velocity sensors (relative) for the robot, but I don't know (...) (27 years ago, 16-Jan-98, to lugnet.robotics.handyboard)
| | | | | Re: Shaft encoder
|
| (...) Hi there, Would these chips be suitable for interfacing a mouse to the Handyboard? My robot incorporates a mouse as a castor wheel and I want to use its shaft encoders as position/velocity sensors (relative) for the robot, but I don't know (...) (27 years ago, 16-Jan-98, to lugnet.robotics.handyboard)
| | | | | Handy board troubles.
|
| I have various handyboard and i never use the IR ports. So i'm assembling one handy, and don't put al the components asociated to that ports. I download anyprogram to that's board and never boot again!!!! The transmision is o.k. but don't start (...) (27 years ago, 16-Jan-98, to lugnet.robotics.handyboard)
|
|
