 | | Re: LEGO motors and the handyboard ?
|
|
Cutting the trace is only ONE solution! I had the same problem and did not consult the handyboard FAQ on the web. This FAQ gives you some options if you don't want to damage your board. Another solution is to use your own custom H-bridge, or do like (...) (27 years ago, 20-Sep-97, to lugnet.robotics.handyboard)
|
| |
| | Re: Pseudocode
|
|
(...) One thing to remember: the input is the world (through the sensors) and the output are the robots actions on the world. A program outline repeat turn on drive motors repeat read wall/obstacle sensor until sensor reads an obstacle stop motors (...) (27 years ago, 19-Sep-97, to lugnet.robotics.handyboard)
|
| |
| | Re: LEGO motors and the handyboard ?
|
|
The HB gets reset due to the large current drawn from the motors. You should separate HB and motors power supply. What you need is to cut the trace (+ve motor power share with HB main power) nearby J13. Then, apply motors power supply to J13 and (...) (27 years ago, 19-Sep-97, to lugnet.robotics.handyboard)
|
| |
| | Pseudocode
|
|
Hello, Im very new to the list and to the entire concept of all of it basically. but- i'll cut to the chase (its breif) Just learning c programming i ran across a chapter in the book which explains pseudocode and its impact. I dont know how many (...) (27 years ago, 19-Sep-97, to lugnet.robotics.handyboard)
|
| |
| | Handyboard and TTL ?
|
|
L.S. I come across all nice little modules wich send out TTL signals like light sensors, clock modules etc. I would like to use a couple of them to spice up my robot but haven't got a clue what TTL is and how to use it. I tried to look on the (...) (27 years ago, 19-Sep-97, to lugnet.robotics.handyboard)
|
