 | | Substitute processor question
|
|
I was looking at the page (URL) instructions on starting the handy board as I just completed the interface. From the parts list, either the MC68HC11A1FN or the MC68HC11E1FN are acceptable, but on this page, the picture of the handy board has an A0FN (...) (27 years ago, 20-Jun-97, to lugnet.robotics.handyboard)
|
| |
| | Magnetic Card Readers again...
|
|
I have found the code from dave negro, but i'm can make work this with my handy... Nothing more has tried this with interactive C(code in C). ===...=== Obtenga su e-mail GRATUITO para toda la vida en: (URL) (27 years ago, 20-Jun-97, to lugnet.robotics.handyboard)
|
| |
| | Photocell problems
|
|
I was wondering if someone could check out this code. I got it to work w/ just the touch sensors and motors. But I added photocells to it and added the code in for that and now the LCD panel reads....231>Press START after I press start it says... (...) (27 years ago, 19-Jun-97, to lugnet.robotics.handyboard)
|
| |
| | Re: I'm happy !!!
|
|
---...--- (...) use (...) My (...) the (...) (27 years ago, 19-Jun-97, to lugnet.robotics.handyboard)
|
| |
| | Trouble with MAX232
|
|
Just starting with the HB and already problems Im having problems getting the 9 to 10 volts out of pins 3-7 of J9 (the RS232 connector) when pins 6 and 10 of the MAX232 are shorted in the last paragraph of step 3.2.2. Everything else up to this poit (...) (27 years ago, 18-Jun-97, to lugnet.robotics.handyboard)
|
