 | | Shaft Encoder
|
|
Hi, Do anyone know how to connect up two channel shaft encoder and able to read in the direction of turning? Please help... Johnny (27 years ago, 8-Jun-97, to lugnet.robotics.handyboard)
|
| |
| | RE: HBDL still not working with win95...
|
|
2 things to try... first... slow down the baud... 9600 should be fine for a 64k program... it may take a min but how much speed do you need?... if that works... try 19200, 38700, blah blah blah... if neither of those work... jump into your bios and (...) (27 years ago, 8-Jun-97, to lugnet.robotics.handyboard)
|
| |
| | HBDL still not working with win95...
|
|
Big thanks to everyone who respnded to my original question. I have essentially ruled out an IRQ conflict. I have a PS/2 mouse (IRQ 12) and only com1 (serial port) and com2 (modem) are enabled. HBDL always returns the addressing error while (...) (27 years ago, 8-Jun-97, to lugnet.robotics.handyboard)
|
| |
| | Serial IO
|
|
I am trying to get my handyboard communicating with a TurboC program through the com2 port on my computer. I have been attempting to use the routine found in serialio.c on the website. Say I have an infinite loop setup on my handyboard that looks (...) (27 years ago, 8-Jun-97, to lugnet.robotics.handyboard)
|
| |
| | Using HBDL with a fast Pentium?
|
|
Hi all, I've seen questions about this before, but can't recall anyone posting a solution. The problem is that I can't get HBDL to work in Win95 on a P166. When trying to download, the process works okay until I get an error dialog box that says: (...) (27 years ago, 7-Jun-97, to lugnet.robotics.handyboard)
|
