| | Re: Re[4]: IR Collision avoidance
|
|
Richard, Please send me the schemtics on the $2 circuit and whatever else I need to know to get this thing up and running. I would appreciate this very much. Thanks. (...) (28 years ago, 7-Mar-97, to lugnet.robotics.handyboard)
|
|
| | IR sensors
|
|
Is there any sort of "pre-built" IR module to interface IR to the handyboard. Perhaps a schematic or something? Thanks ---...--- Adam B. Cox check out my web page Computer Engineer (URL) Communications Corp. vmail: 416-241-7000 (x224) ---...--- (28 years ago, 7-Mar-97, to lugnet.robotics.handyboard)
|
|
| | Problem with H-Drives
|
|
I've been having problems with the Handy Board being able to go into download mode. It seems to work fine without any motor drivers connected, and with one driver chip plugged into one side of the board, it also seems to work, but still not (...) (28 years ago, 7-Mar-97, to lugnet.robotics.handyboard)
|
|
| | vector2x
|
|
Does anyone have schematics or know where I can download schematics on the hookup of the v2x compass? Thanks. ---...--- Adam B. Cox check out my web page Computer Engineer (URL) Communications Corp. vmail: 416-241-7000 (x224) ---...--- (28 years ago, 7-Mar-97, to lugnet.robotics.handyboard)
|
|
| | Re: SPI & Vector2x
|
|
(...) Maybe, it'll depend on the flooring. I think re-bar in a concrete floor might affect a compass too close to the floor. Last night I was playing with the compass, and found that passing a screwdriver within about 3 inches would affect the (...) (28 years ago, 7-Mar-97, to lugnet.robotics.handyboard)
|