|
|
 | | IR LED's
|
| Hi Bill, Are you able to transmit IR beams through more than one LED (eventhough the handy board has only one LED driver port). If this is part of your IC code, could u please mail it to the net. Thanks Sriram (28 years ago, 15-Feb-97, to lugnet.robotics.handyboard)
| | | | | SPI Routines in IC
|
| Anybody have any routines or know of any published information for using the SPI with IC for: ...use with Dallas Semi's serial real time clock - DS1202 ...use with 12 Bit serial A/D - LT1298 ...use with Dallas semi's Thermomerter - DS1620 Thanks a (...) (28 years ago, 15-Feb-97, to lugnet.robotics.handyboard)
| | | | | Re: Motors & handyboard
|
| (...) 3v toy motors are noisy little buggers and were never designed to be anywhere near a microprocessor. if you reduced the hb motor battery supply to 3v, you might have a chance. at 9v, i really doubt it. -f (...) (28 years ago, 15-Feb-97, to lugnet.robotics.handyboard)
| | | | | Motors, gear boxes, tools
|
| Greetings: on the Hanyboard web page, Tower Hobbies is mentioned as source for RC supplies etc. I would reccommend highly for electric motors, gear boxes, tools including a nice metal turning lathe, Hobby Lobby International www.hobby-lobby.com (...) (28 years ago, 15-Feb-97, to lugnet.robotics.handyboard)
| | | | | Re: Motors & handyboard
|
| To measure current with an multimeter or ammeter (volt/ohm/etc.. meter) you must break the circuit at some point and put the meter in series with the circuit thus gapping the break. ie) +-----(+) METER (-)------+ | | | | (+) | POWER | (-) | | | | | (...) (28 years ago, 15-Feb-97, to lugnet.robotics.handyboard)
|
|
