|
| | Re: Port E inputs
|
| the 6.270 has a diff anlg ckt. remember, the app b is generally applicable, but some details are different. -f In your message you said: (...) (28 years ago, 14-Feb-97, to lugnet.robotics.handyboard)
| | | | dual servos
|
| Hello everyone, I have been fiddling with my dual servo routines and I have gotten things running to the point that I now need a chassis for my project. While working on the drive system I have noticed that when under heavy motor load (2 motors at (...) (28 years ago, 14-Feb-97, to lugnet.robotics.handyboard)
| | | | Port E inputs
|
| Hello, I noticed that in Figure B.9 on page 194 in Appendix B of the 6.270 manual that pins PE0-PE3 are shown to go to seperate little port symbols while pins PE4-PE7 go to a block labeled 'Analog Input Header'. Do these inputs really go to two (...) (28 years ago, 13-Feb-97, to lugnet.robotics.handyboard)
| | | | (Kein Bezug)
|
| help (28 years ago, 13-Feb-97, to lugnet.robotics.handyboard)
| | | | LM324
|
| The latest expansion board schematic shows an LM324 for the high impedance input buffers. Although the LM324 is cheap and available, its input and output voltage ranges are limited to 0 to 3.5V (yes, probably a little more with any real part). If (...) (28 years ago, 13-Feb-97, to lugnet.robotics.handyboard)
| |