Subject:
|
Port E inputs
|
Newsgroups:
|
lugnet.robotics.handyboard
|
Date:
|
Thu, 13 Feb 1997 23:45:23 GMT
|
Original-From:
|
Luke <umaskin0@cc&NoMoreSpam&.umanitoba.ca>
|
Viewed:
|
1526 times
|
| |
|
|
Hello,
I noticed that in Figure B.9 on page 194 in Appendix B of the 6.270
manual that pins PE0-PE3 are shown to go to seperate little port symbols
while pins PE4-PE7 go to a block labeled 'Analog Input Header'. Do these
inputs really go to two physically different connectors? On the
handy-board it appears as if the analog inputs all go to one female
socket strip on the lower left corner of the board. Is this correct? If
so, do the numbers on the board, 0-6 correspond to PE0-PE6 respectively?
Thanks.
-Luke
|
|
Message has 1 Reply:
 | | Re: Port E inputs
|
| the 6.270 has a diff anlg ckt. remember, the app b is generally applicable, but some details are different. -f In your message you said: (...) (28 years ago, 14-Feb-97, to lugnet.robotics.handyboard)
|
2 Messages in This Thread:
 
- Entire Thread on One Page:
- Nested:
All | Brief | Compact | Dots
Linear:
All | Brief | Compact
|
|
|
|
